Configuring A Remote Maintenance End Point - Avaya 2330 Manual

Ethernet Connectivity Fault Management configuration

Configuring a remote Maintenance End Point

Use the procedure in this section to define a remote MEP within an MA. Each MEP and remote
MEP must have a unique ID within an MA. Ensure that no MEP and remote MEP use the same
ID.
Procedure steps
1. To access configuration mode, enter:
2. To access the Ethernet OAM tools to configure CFM, enter:
3. To configure CFM, enter:
4. To create an MD, or to specify a previously created MD, enter:
5. To create an MA, or to specify a previously created MA, enter:
6. To create a remote MEP, enter:
Table 17: Variable definitions
ma <WORD>
[mac addr]
md <WORD>
<rmep id>
58 Configuration — Layer 2 Ethernet
configure terminal
oam
cfm
md <WORD>
ma <WORD>
rmep <rmep id> [mac addr]
Variable
Comments? infodev@avaya.com
Value
The short name for the MA (up to eight
characters). For example,
The MAC address of the host. Enter the MAC
address in the form aa:bb:cc:dd:ee:ff. This
parameter is optional. The Secure Router
2330/4134 can auto-detect remote MEPs.
The short name of the MD (up to eight
characters). For example
The numerical identifier for the remote MEP.
There is no default value. Enter a value in the
range from 1 to 8191. For example,
111 .
MA1 .
MD1 .
rmep
July 2013