Table 81: Variable definitions
<instance id>
<vid>
Removing a VLAN from an MSTP instance
Use the procedure in this section to remove a VLAN from an MSTP instance.
Procedure steps
1. To access configuration mode, enter:
2. To access the bridge command context, enter:
3. To access the MSTP command context, enter:
4. To select the MSTP instance, enter:
5. To remove a VLAN from the MSTP instance, enter:
Table 82: Variable definitions
<instance id>
<vid>
Configuring priority for an instance
You can assign a priority value for a bridge associated with an instance. The lower the priority,
the greater the chance the bridge becomes root for that instance. Use the procedure in this
section to configure priority for an instance.
Configuration — Layer 2 Ethernet
Variable
configure terminal
bridge
mstp
instance <instance id>
no vlan <vid>
Variable
Value
Specifies the MSTP instance ID. Valid values
are 0 to 15.
Specifies the VLAN ID to associate with the
MSTP instance. Valid values are 1 to 4000.
Value
Specifies the MSTP instance ID. Valid values
are 0 to 15.
Specifies the VLAN ID to remove from the
MSTP instance. Valid values are 1 to 4000.
Configuring an MSTP instance
July 2013
159