Power over Ethernet configuration
Configuring PoE device detection
Use the procedure in this section to enable 802.3af-compliant device detection.
Procedure steps
1. To access configuration mode, enter:
2. To enable 802.3af-compliant device detection, enter:
Table 7: Variable definitions
<slot>
Configuring PoE port power limits
Use the procedure in this section to configure PoE port power limits.
48
Configuration — Layer 2 Ethernet
Variable
configure terminal
poe detect3af <slot>
Variable
Comments? infodev@avaya.com
Value
Use the
no poe portpriority
<slot/port> <port priority>
command to reset the port priority to the
default value (3). This command also
removes the port priority configuration for
this port from the running configuration.
Value
Specifies the slot in which the interface
module is installed on which you enable
802.3af-compliant device detection. Valid
values for <slot> are 5, 6, and 7. When
disabled, both 802.3af compliant devices
and legacy devices are detected.
For example, if you configure
detect3af <5>
, only legacy devices are
detected in the ports of the module inserted
in slot 5.
Use the
no poe detect3af <slot>
command to disable 802.3af detection for the
module in slot <slot>.
802.3af is disabled by default.
poe
July 2013