Enabling Gvrp On Ports And Configuring Port Registration State - Avaya 2330 Manual

GVRP configuration
3. To disable GVRP globally, enter:
Enabling GVRP on ports and configuring port registration
state
GVRP runs only on ports that are configured for 802.1Q trunking.
Use the procedure in this section to enable GVRP on an individual 802.1Q trunk port.
Important:
You must configure GVRP on both sides of the trunk.
By default, GVRP ports are in the "normal" registration mode. The ports use GVRP join
messages from neighboring devices to prune the VLANs running across the 802.1Q trunk link.
If the device on the other side is incapable of sending GVRP messages, or if you do not want
to allow the Avaya Secure Router 2330/4134 to prune any of the VLANs, use the "fixed" mode.
Fixed mode ports will forward for all VLANs that exist in the switch database. Ports in forbidden
mode forward only for VLAN 1.
Prerequisites
• Trunk port configuration must be complete.
Procedure steps
1. To access configuration mode, enter:
2. To select the previously-configured trunk port, enter:
3. To access the GVRP command context, enter:
4. To enable the port for GVRP, enter:
5. (Optional) To configure the port registration state, enter:
168 Configuration — Layer 2 Ethernet
gvrp
no gvrp-enable
configure terminal
interface [range] ethernet <slot/port>
gvrp
gvrp-enable
registration-state {normal|fixed|forbidden}
Comments? infodev@avaya.com
July 2013