Table of Contents
Advertisement
Before You Begin
1. Connect the male end of the DB-25 adapter to the female DB-25 port on the
2. Connect one end of a supplied RJ-45 cable to the RJ-45 port in the DB-25
3. Connect the other end of the RJ-45 cable to the Console port on the SR1000.
4. Configure the modem for 9600 bps, 8 data bits, 1 stop bit, no parity, and XON/XOFF
If a workstation is used for the remote management console, use VT-100 terminal emulation
software or equivalent, and configure the software as specified for modems.
Configuring the Secure Router
The following sections introduce commands that you can use to log in as the system
administrator using the default username and password, choose a host name, change the
password, set the system date and time, enter an Ethernet IP address, establish a default
route, switch modes, and save the configuration.
Logging In
Login: Admin
Password: Setup
Choosing a Host Name
SR> configure term
SR/configure> hostname ISP_name
ISP_name/configure>
Changing the Password
SR> password
name: Admin
old password: Setup
new password: new_pass
re-enter password: new_pass
Passwords are case-sensitive and must be a minimum of three to a maximum of eight
characters. For future reference, make a note of the password that you use.
36
Avaya Secure Router 1000 Series Quick Start Guide
modem.
adapter.
flow control. Refer to your modem documentation, if necessary. Consult the Avaya
Support website for additional configuration information.
Comments? infodev@avaya.com
June 2012
Advertisement
Table of Contents
