Disabling Trunking - Avaya 2330 Manual

2. To select an interface, enter:
3. To add a specific VLAN to the selected trunk link, enter:
Removing a specified VLAN from a trunk link
Use the procedure in this section to selectively remove VLANs from a trunk link.
Procedure steps
1. To access configuration mode, enter:
2. To select an interface, enter:
3. To remove a specific VLAN from the selected trunk link, enter:

Disabling trunking

Use the procedure in this section to disable trunking on an interface.
Procedure steps
1. To access configuration mode, enter:
2. To select an interface, enter:
3. To disable trunking on the interface, enter:
Configuration — Layer 2 Ethernet
configure terminal
interface [range] ethernet <slot/port>
switchport trunk allowed vlan <vid>
Note:
To add multiple VLANs to the selected trunk link, enter each VLAN ID separated
by a comma. For example, switchport trunk allowed vlan 2,3
configure terminal
interface [range] ethernet <slot/port>
switchport trunk remove vlan <vid>
configure terminal
interface [range] ethernet <slot/port>
no switchport
Configuring trunking on Ethernet interfaces
July 2013 87