Configuring Poe Port Power - Avaya 2330 Manual

Power over Ethernet configuration
<slot/port>

Configuring PoE port power

Use the procedure in this section to enable power on a port.
Procedure steps
1. To access configuration mode, enter:
2. To enable power on a port, enter: poe portpower <slot/port>
Table 5: Variable definitions
<slot/port>
46 Configuration — Layer 2 Ethernet
Variable
configure terminal
Variable
Comments? infodev@avaya.com
Value
either "auto" or "static". Port power is
always disabled in "never" mode.
Use the no poe portmode <slot/
port> <mode>
command to reset the port
mode to the default value of "auto".
You can enable or disable port power at any
time using the poe portpower
for ports configured in either auto mode or
static mode.
Important:
When the system comes up for the first
time, power is disabled for safety reasons,
even though ports are in auto mode.
Specifies the slot and port number that
identify the port to configure. Valid values for
slot are 5 to 7. Valid values for port are 1 to
24.
Value
Specifies the slot and port number that
identify the port to configure. Valid values for
slot are 5 to 7. Valid values for port are 1 to
24.
• poe portpower <slot/port>
enables power on port <slot/port>. You can
configure this only when the mode of
operation is "auto" or "static" mode. If you
use this command when the mode of
operation is "never", the command has no
command
July 2013