Changing The Vlan On An Access Port - Avaya 2330 Manual

Interface mode configuration
4. To configure the encapsulation for the bundle, enter:
5. To configure the interface as an access port, enter:
Table 41: Variable definitions
<bundle-name>
{ppp | fr}
<slot/port>
<type>

Changing the VLAN on an access port

Use the procedure in this section to change the VLAN assigned to an access link.
Procedure steps
1. To access configuration mode, enter:
2. To select an interface, enter:
3. To assign a VLAN to the selected access port, enter:
102 Configuration — Layer 2 Ethernet
link <type> <slot/port>
encapsulation {ppp|fr}
switchport
Variable
configure terminal
interface bundle <bundle-name>
switchport pvid <vid>
Comments? infodev@avaya.com
Value
Specifies the name of the bundle. For
example, T1IF.
Specifies the encapsulation. You can
configure an access link only on WAN
interfaces that are configured with PPP or FR
encapsulation.
Specifies the slot and port numbers that
identify the port on which you enable an
access link. For example, 7/1.
Specifies the type of WAN interface. For
example, t1. For detailed information on
WAN interfaces that support PPP or FR
encapsulation, see Avaya Secure Router
2330/4134 Configuration — WAN
interfaces (NN47263-500).
July 2013