Verifying The Successful Configuration Of A Lag; Viewing Channel-Group Information; Viewing Aggregator Member Information; Viewing Lacp Dynamic Information - Avaya 2330 Manual

4. To configure the LAG interface as a trunk link, enter:
5. To add all VLANs to the trunk, enter:
Table 48: Variable definitions
lag<id>

Verifying the successful configuration of a LAG

Use the procedures in this section to verify successful operation of your LACP configuration.

Viewing channel-group information

Use the procedure in this section to view channel-group information.
Procedure steps
To view channel-group information, enter:
show lacp channel-group

Viewing aggregator member information

Use the procedure in this section to view aggregator member information.
Procedure steps
To view information about aggregator members, enter:
show lacp member-port

Viewing LACP dynamic information

Use the procedure in this section to view LACP dynamic information.
Configuration — Layer 2 Ethernet
switchport
switchport mode trunk
switchport trunk allowed vlan all
Variable
Verifying the successful configuration of a LAG
Value
The LACP interface bundle. The <id> value
is a channel group ID. For example, lag1.
Valid values are 1 to 8.
July 2013 111