Configuring a Maintenance Association
Use the procedure in this section to define an MA within an MD.
Procedure steps
1. To access configuration mode, enter:
2. To access the Ethernet OAM tools to configure CFM, enter:
3. To configure CFM, enter:
4. To create an MD, or to specify a previously created MD, enter:
5. To create an MA, enter:
6. To specify the full name for the MA, enter:
7. To specify the VLAN with which the MA is associated, enter:
Table 15: Variable definitions
ma <WORD>
md <WORD>
name <WORD>
Configuration — Layer 2 Ethernet
Variable
configure terminal
oam
cfm
md <WORD>
ma <WORD>
name <WORD>
vlan <vid>
Variable
Configuring a Maintenance Association
Value
CCM, if you configure a full name for the MD.
If you do not configure a full name, the short
name of the MD is used in CCM.
Value
The short name for the MA (up to eight
characters). For example,
The short name of the MD (up to eight
characters). For example
The full name of the MA (up to 31
characters). Place quotation marks around
the full name. For example,
full name"
.
MA1
.
MD1
.
name "MA 1-
July 2013
55