Configuring Loopback Interfaces
All CLI commands mentioned in this section are described in the X330WAN User's
Guide.
To configure Loopback interfaces:
1
Use the
interface loopback <loopback number>
Loopback mode. For example, typing
Loopback interface number 1.
The prompt changes to
where N is the switch number and n is the loopback interface number.
2
Use the
ip address <ip_addr> <net-mask>
mask to the interface.
The following is displayed:
The primary management interface has changed. For this change to
take effect, you need to copy running-config startup-config and
then reset the device.
3
Type exit to return to Supervisor mode. The prompt returns to X330WAN-2USP-N(super)#.
4
Enter the
copy running-config startup-config
5
Check that the running state is "idle" by entering the
6
Reset the switch using the
Configuring FastEthernet Interfaces
All CLI commands mentioned in this section are described in the X330WAN User's
Guide.
To configure FastEthernet interfaces:
1
Use the
interface FastEthernet <if-number>
Configuration mode, where the if-number format is
You do not need to include the ip-interface index if you configure only one IP interface.
The prompt changes to
interface number.
5
2
Use the
ip address <ip_addr> <net-mask>
mask to the interface.
3
Type
to return to Supervisor mode.
exit
The prompt returns to
interface loopback 1
X330WAN-2USP-N(super-if:Loopbackn)#
command to assign an IP address and subnet
command.
reset
X330WAN-2USP-N(super-if:FastEthernetn)#, where n is the
command to assign an IP address and subnet
X330WAN-2USP-N(super)#
command to enter the Interface
configures a loopback with a
command.
show copy status
command to enter the Interface
port[.ip-interface index]
.
command
.