Link aggregation configuration
Removing LACP configuration
Use the procedure in this section to remove LACP configuration from an interface.
Procedure steps
1. Enter configuration mode:
2. To select an interface, enter:
3. Enter the configuration context:
4. Remove LACP configuration from the selected interface:
Configuring the LACP timeout
Use the procedure in this section to configure the LACP timeout value.
Procedure steps
1. Enter configuration mode:
2. To select an interface, enter:
3. Enter the configuration context:
4. To configure the timeout value, enter:
Table 45: Variable definitions
<short | long>
108
Configuration — Layer 2 Ethernet
configure terminal
interface ethernet <slot/port>
lacp
no channel-group <value> {static|mode <active|passive>}
configure terminal
interface ethernet <slot/port>
lacp
timeout <short|long>
Variable
Comments? infodev@avaya.com
Value
Specifies an interval of time between LACP
Protocol Data Units (PDUs), after which the
bridge considers the LACP link partner to be
July 2013