Fig. 4-8 Connecting To Fm Stepdrive And Simodrive Drive Units - Siemens SIMATIC FM 453 Manual

Connecting Servo In the case of mixed configurations, the drives are permanently assigned to
and Step Drives
the terminals of the separate channels.
You should always start with the step drives.
Example:
Connecting one step drive and two servo drives.
Step drive on channel 1
1. Servo drive on channel 2
2. Servo drive on channel 3.
Connecting two step drives and one servo drive.
1. Step drive on channel 1
2. Step drive on channel 2
Servo drive on channel 3
Connecting cable
The connecting cables are a cable set for three channels with:
The connecting cable is available in a variety of lengths.
For length code, see
Fig. 4-8
In both configurations, the signal READY2 can be used alternately.
FM 453 Servo Drive / Step Drive Positioning Module
C79000-G7076-C453-01
One step drive and two servo drives
– Order No.: 6FX2 002-3AB02-1
Two step drives and one servo drive
– Order No.: 6FX2 002-3AB03-1
X5
READY2
(channels 1 to 3)
FM 453
Connecting cable
Connecting to FM STEPDRIVE and SIMODRIVE Drive Units
Wiring the FM 453
Order No.: E86060-K4490-A001-A4
Drive unit e.g. FM STEPDRIVE
SIEMENS SIEMENS
SIMODRIVE 611-A
4-15