Siemens SIMATIC FM 453 Manual page 337

Table 11-7 Travel Errors, continued
Cl. No.
Travel errors
3 (03) 65 (41) No drive movement
Cause
Effect
Elimina-
tion
3 (03) 66 (42) Following error too great
Cause
Effect
Elimina-
tion
3 (03) 67 (43) Boost duration absolute exceeded
Cause
Effect
Elimina-
tion
3 (03) 68 (44)
Boost duration relative exceeded
Cause
Effect
Elimina-
tion
Cl. = Detail event class, No. = Detail event number, CBS = Checkback signals, DB = Data block
Note: Value (xx) = Hexadecimal notation of the error number.
FM 453 Servo Drive / Step Drive Positioning Module
C79000-G7076-C453-01
Error Message,
Error Analysis and Elimination
Error response : "Feed STOP" see Table 11-2
Axis standstill at maximum drive control signal ( 10 V).
On violation of the defined following error limit.
Acceptance of actual value (internally like "follow-up mode").
Check drive/connecting cables.
Check controller enable signal between FM 453 and drive.
Excessive following error during axis movement.
Check drive.
Check MD23, MD43.
Acceleration phase too long.
Check MD48.
Change drive configuration.
Change technology (axis traversing cycle).
Acceleration phases too high in component compared with idle/
constant travel
Check MD49.
Change drive configuration.
Change technology (axis traversing cycle).
Troubleshooting
Message/
Display
CBS
CBS
CBS
CBS
11-21