Siemens SIMATIC FM 453 Manual page 172

Starting up the FM 453
Step drive
Set the following machine data to initial values for the following optimiza-
tion steps:
Optimization of dy-
The qualitative effect of the parameters on the positioning procedure is illus-
namic response
trated by the following table:
Table 7-5
Quiet running
Noise immunity
Soft movement reversal
Positioning without overshooting
Fast positioning
You can use the following startup actions to optimize position control to your
requirements if necessary. Check all speed ranges, and if applicable give the
greatest weight in evaluating the results to the speed that is the most signifi-
cant for your technology.
These startup actions are only possible for servo drives
(MD61 = 0) or step drives (MD61 = 1) when encoders are used.
7-30
Acceleration, delay
MD40 = MD41 = according to operating characteristic curve, see Section
7.3.2 "Procedure"
Jolt time
MD42 = 0
Positioning loop amplification
MD38 [1/min] = 1 000 = default value
Minimum standstill time, minimum traversing time
MD46 = MD47 = 100 ms
These parameters are less important in servo-controlled operation, be-
cause a gentle movement reversal already exists due to the time response
in the position control circuit. The values can usually be reduced by 1 ms
in the direction of the minimum values. (For a description of these param-
eters, see Section 7.3.8, "Optimization of dynamic response")
Effect of Machine Data that Defines Response in the Position Control
Circuit
MD38 MD40/41
small –
great –
small great
small great
great small
FM 453 Servo Drive / Step Drive Positioning Module
C79000-G7076-C453-01
MD42
–
–
great
great
small