Table of Contents
Advertisement
Man-Machine Interface
What Can I Control
Using the keyboard of the operator panel, you can change the data/signals in
on the FM 453?
the data blocks:
What Can I
The following data and signals can be displayed on the operator panel dis-
Monitor on the
play:
FM 453?
The configuration package includes a pre-configured interface for the
COROS OP 17 device.
8-2
Machine data
DB No. 1205 for channel 1
DB No. 1505 for channel 2
DB No. 1805 for channel 3
Increments
DB No. 1230 for channel 1
DB No. 1530 for channel 2
DB No. 1830 for channel 3
Tool offset data
DB No. 1220 for channel 1
DB No. 1520 for channel 2
DB No. 1820 for channel 3
Traversing programs
DB No. 1001...1199 for channel 1
DB No. 1301...1499 for channel 2
DB No. 1601...1799 for channel 3
Machine data, see above
Increments, see above
Tool offset data, see above
Traversing programs, see above
Status messages
DB No. 1000 for channel 1
DB No. 1300 for channel 2
DB No. 1600 for channel 3
e.g.
– Operating data, such as actual values
– Active NC blocks
– Linear measurements
– Actual value block change
– Check-back signals and error conditions
– Servicing data
FM 453 Servo Drive / Step Drive Positioning Module
C79000-G7076-C453-01
Advertisement
Table of Contents
