Table of Contents
Advertisement
7.2
Initial Values for Testing and Optimization
Parameterization
You can find information about parameterization:
Information
Overview
The following opening display appears in the "Parameterize FM 453" tool:
Fig. 7-1
You can return to this display at any point during parameterization by select-
ing the menu View Overview.
As it is written to the FM 453, the DB-MD is checked for the input limits of
the individual values and their interdependencies. It is then stored only if all
values are allowed. Otherwise data error messages are displayed by way of
the MPI. A defective DB will not be retained when the power is turned off.
FM 453 Servo Drive / Step Drive Positioning Module
C79000-G7076-C453-01
In Chapter 5 of this manual
In the on-line help in "Parameterize FM 453"
Overview Display for Parameterization and Start-up
Starting up the FM 453
7-3
Advertisement
Table of Contents
