Table of Contents
Advertisement
Installing and Removing the FM 453
3.1
Installing the FM 453
Rules
No particular protective measures (EGB Guidelines) are necessary for the
installation of the FM 453.
Note
Please refer to Appendix B in the manual S7-400/M7-400 Programmable
Controller, Hardware and Installation.
Tools Required
A 4.5 mm (0.18 inch) screwdriver.
Procedure
To install the FM 453:
1. Hook the FM 453 onto the rail and swing it into position.
2. Screw the FM 453 down (torque approx. 0.8 to 1.1 Nm).
3. Attach the sub-D plugs to the encoder and drive unit.
4. Attach the front connector.
5. Fit the connector cover and lock it in place.
6. After the modules have been mounted, you can also assign each of them a
Note
The slot determines the initial address of each module.
3-2
slot number. Slot labels for this purpose are enclosed with the rack.
The numbering scheme and how to plug in the slot labels are described in
the manual S7-400/M7-400 Programmable Controller, Hardware and
Installation .
FM 453 Servo Drive / Step Drive Positioning Module
C79000-G7076-C453-01
Advertisement
Table of Contents
