Siemens SIMATIC FM 453 Manual page 344

Troubleshooting
Table 11-8 General Data Errors, Machine Data Errors, Traversing Program Errors, continued
Cl. No.
Machine data errors
5 (05) 11 (0B) Travel per encoder revolution
12 (0C) Distance to go per encoder revolution
13 (0D) Increments per encoder revolution
14 (0E) Number of revolutions, absolute encoder
Cause
Effect
Elimina-
tion
5 (05) 15 (0F) Baud rate, absolute encoder
Cause
Effect
Elimina-
tion
5 (05) 16 (10) Reference point coordinates, absolute encoder adjustment
17 (11) 17 (11)
Cause
Effect
Elimina-
tion
5 (05) 18 (12) Type of reference point travel
Cause
Effect
Elimina-
tion
5 (05) 19 (13) Direction matching undefined
Cause
Effect
Elimina-
tion
5 (05) 20 (14)
Disable hardware monitoring undefined
Cause
Effect
Elimina-
tion
Cl. = Detail event class, No. = Detail event number, CBS = Checkback signals, DB = Data block
Note: Value (xx) = Hexadecimal notation of the error number.
11-28
Error Message,
Error Analysis and Elimination
Error response: "Warning" see Table 11-2
Impermissible value range or dependency violation on
no. 11, 12, 13 (see Section 5.3.1).
DB does not become effective and is stored non-retentively.
Correct and retransmit.
Unacceptable baud rate.
DB does not become effective and is stored non-retentively.
Correct and retransmit.
Unacceptable value range.
DB does not become effective and is stored non-retentively.
Correct and retransmit.
Unacceptable type of reference point travel.
DB does not become effective and is stored non-retentively.
Correct and retransmit.
Direction matching undefined.
DB does not become effective and is stored non-retentively.
Correct and retransmit.
Disable hardware monitoring undefined.
DB does not become effective and is stored non-retentively.
Correct and retransmit.
FM 453 Servo Drive / Step Drive Positioning Module
C79000-G7076-C453-01
Message/
Display
CBS
or
DB
CBS
or
DB DB
CBS
or
DB DB
CBS
or
DB DB
CBS
or
DB DB
CBS
or
DB DB