Siemens SIMATIC FM 453 Manual page 4

Preface
User Requirements
The present manual describes the hardware and functions of the FM 453.
To set up, program and start up a SIMATIC S7-400 with the FM 453, you
will need a knowledge of:
FM 453 Users
The structure and presentation of the information in the manual are oriented
to the intended uses of the FM 453, and the user's own activity.
It distinguishes among the following:
iv
Reference information and appendices for finding factual information
(module functions, programming guide, interface signals, error handling,
technical specifications, standard HMI user interface)
List of abbreviations and index for looking up information.
The SIMATIC S7
S7-400/M7-400 Programmable Controllers, Hardware and Installation
manual
Your programming device (PG)
How to perform programming with STEP 7
How to configure an operator panel interface.
Installation
These activities include installation and wiring of the FM 453.
Programming
These activities include parameterizing and programming the FM 453.
Troubleshooting and diagnostics
These activities include detecting and correcting faults and errors
– in the hardware setup of the module and its components
– and in the programming, handling and control of module functions.
Operation
These users operate the FM 453. The operator accordingly deals only with
the control of positioning tasks.
FM 453 Servo Drive / Step Drive Positioning Module
C79000-G7076-C453-01