Table of Contents
Advertisement
Chapter
Overview
8.1
8.2
8.3
8.1
Standard HMI (Human-Machine Interface) for the OP 17
Overview
This Section describes a preconfigured user interface, which you will need to
change according to your project (e. g. FM addresses, DB no.), for the
COROS equipment (operator panel): OP 17
The tool to be used for this is the configuring tool "ProTool/Lite" or ProTool
V3.0. You can use it to modify, add or delete screens.
The user interface is addressed to:
The OP 17 has been addressed in this example configuration to the MPI ad-
dress 9.
The text field "FM user name" represented in the images can be renamed to a
text of your choice.
You can print out the entire configuration using "ProTool/Lite" V3.0. This
provides you with detailed screen descriptions.
You will find the preconfigured user interface in the following directory:
SIEMENS\STEP7\EXAMPLES\S7OP_BSP\01743_1a.pdb
DB-SS
The data block for status messages contains the control/checkback signals, as
well as the system data of the FM 453. The data of the DB-SS can only
be read.
Monitoring
The data for monitoring can be read and displayed directly in the BD-SS as
well as in the corresponding parameterized DBs of the FM 453.
Operator Control
For operator control, the data and signals (including memory bits and values)
are written to the user DB of the user program.
FM 453 Servo Drive / Step Drive Positioning Module
C79000-G7076-C453-01
In Section
Human-Machine Interface for the OP 17
Evaluation of the User DBs by the User Pprogram
Data Block for Status Messages (DB-SS)
user DBs 1, 2 and 3 (channels 1, 2 and 3) in the CPU
(controller: Steuerg_CPU; address = 2; slot = 3)
the data blocks for status messages (DB-SS) 1000, 1300 and 1600 (chan-
nels 1, 2 and 3) in the FM 453 (controller: Steuerg_453; address 2; slot 8)
or to the traversing program.
Man-Machine Interface
You Will Find
On Page
8-3
8-7
8-11
8-3
Advertisement
Table of Contents
