Table of Contents
Advertisement
5.5
Storing the Parameter Data in SDB
Overview
The FM 453 stores its parameter data internally.
In order to ensure that the parameter data are available if there is a fault on
the FM 453 and no programming device/PC is at hand, the data can be stored
in a system data block in the CPU (SDB
data stored in SDB
If the FM 453 has no machine data or the internal time stamp (time of cre-
ation) is invalid, the data are transferred from SDB
and saved there.
You must ensure that the parameter data in SDB
the parameter data on the FM 453 when start-up is complete.
Note
SDB
If you need to modify the data subsequently, you should generate
SDB
SDB before you load the new one, however the new SDB automatically over-
writes the old one when it is generated. The old SDB and the new SDB do
not have to be allocated the same number.
Creating the SDB
Prerequisite: Online connection with the FM 453
Fig. 5-9
FM 453 Servo Drive / Step Drive Positioning Module
C79000-G7076-C453-01
1 000 to the FM 453 on each new start.
1 000 should not be created until start-up is finished.
1 000 again and load it into the CPU. You can delete the previous
Select menu File
Create SDB
If no DB-MD exists on the FM 453
An associated SDB
1 000
exists for the FM 453 in the
S7 project.
Yes
Overwrite this SDB?
Yes
SDB is created and stored in the S7 project in
CPU\S7-Program\Blocks\System data
Creating SDB
1 000
Defining Parameters of the FM 453
1 000
1 000). The CPU transfers the
1 000 to the FM 453
1 000 always match
Abort
No
No associated SDB
exists
No
Abort
5-31
Advertisement
Table of Contents
