Siemens SIMATIC FM 453 Manual page 352

Troubleshooting
Table 11-8 General Data Errors, Machine Data Errors, Traversing Program Errors, continued
Cl. No.
Traversing program errors Error response: "Warning"
8 (08) 31 (1F) Velocity missing
Cause
Effect
Elimina-
tion
8 (08) 32 (20) Error, callup subroutine
Cause
Effect
Elimina-
tion
8 (08) 33 (21) D function unacceptable
Cause
Effect
Elimina-
tion
8 (08) 34 (22) Incorrect program length
Cause
Effect
Elimina-
tion
Cl. = Detail event class, No. = Detail event number, CBS = Checkback signals, DB = Data block
Note: Value (xx) = Hexadecimal notation of the error number.
11-36
Error Message,
Error Analysis and Elimination
No velocity was programmed.
Program/block not stored.
Correct program, per cause.
Block syntax for callup subroutine is incorrect.
Program is not stored.
Correct program, per cause.
Block syntax for invoking a D function is incorrect.
Program is not stored.
Correct program, per cause.
Maximum block number exceeded.
Program is not stored.
Correct program, per cause.
FM 453 Servo Drive / Step Drive Positioning Module
C79000-G7076-C453-01
Message/
Display
CBS
or
DB DB
CBS
or
DB DB
CBS
or
DB DB
CBS
or
DB DB