Table of Contents
Advertisement
9.3
System Data
Overview
This chapter describes settings and functions that apply in multiple modes,
and that are likewise necessary in order to control and operate the FM 453,
and data of the FM available for checkback messages.
These settings/functions, which you can activate by calling FC 2 or FC 3 (see
Section 6) with the appropriate job no., are listed in the table below.
Before you call FC 2 with the job no., the corresponding values must be en-
tered in the user DB.
Chapter
Overview
9.3.1
9.3.2
9.3.3
9.3.4
9.3.5
9.3.6
9.3.7
9.3.8
9.3.9
9.3.10
9.3.11
9.3.12
9.3.13
9.3.14
9.3.15
9.3.16
9.3.17
FM 453 Servo Drive / Step Drive Positioning Module
C79000-G7076-C453-01
In Section
Change Parameters/Data (Job No. 8)
Single Functions (Job No. 10)
Single Commands (Job No. 11)
Zero Offset (Job No. 12)
Set Actual Value (Job No. 13)
Set Actual Value On-the-fly (Job No. 14)
Request Application Data (Job No. 18)
Teach In (Job No. 19)
Set Reference Point (Job No. 21)
Measured Values
Basic Operating Data (Job No. 102)
Active NC Block (Job No. 103),
Next NC Block (Job No. 104)
Application Data (Job No. 105)
Actual Value Block Change (Job No. 107)
Servicing Data (Job No. 108)
Additional Operating Data (Job No. 110)
Parameters/Data (Job No. 114)
Description of Functions
You Will Find
On Page
9-36
9-39
9-42
9-44
9-46
9-47
9-48
9-49
9-49
9-50
9-52
9-53
9-54
9-54
9-54
9-55
9-55
9-35
Advertisement
Table of Contents
