Table of Contents
Advertisement
Troubleshooting
Table 11-7
Travel Errors, continued
Cl.
No.
Travel errors
3 (03) 39 (27)
MDI block on the fly, incorrect position or dwell time
Cause
Effect
Elimina-
tion
3 (03) 40 (28)
MDI block on the fly erroneous
Cause
Effect
Elimina-
tion
3 (03) 61 (3D)
Controller enable missing
Cause
Effect
Elimina-
tion
3 (03) 62 (3E)
Controller not ready for operation
Cause
Effect
Elimina-
tion
3 (03) 64 (40)
PEH target area monitoring
Cause
Effect
Elimina-
tion
Cl. = Detail event class, No. = Detail event number, CBS = Checkback signals, DB = Data block
Note: Value (xx) = Hexadecimal notation of the error number.
11-20
Error Message,
Error Analysis and Elimination
Error response : "Feed STOP" see Table 11-2
Position or dwell time is outside allowable values.
9
Position:
10
MSR
Dwell time: > 100000 ms
Input a correct MDI block.
Incorrect block syntax.
Input a correct MDI block.
Traverse command of the
OR
axis without controller
enable (except for "Con-
trol" operating mode).
No axis movement.
OR
Set controller enable by way of user program.
Axis started without
OR
"Controller ready mes-
sage".
No axis movement.
OR
Check drive/connecting cables.
Analysis of the "Controller ready" message can be disabled
by MD37.
Following conclusion of the setpoint value specification to the posi-
tion controller, the target area is not reached within the specified
time.
Check drive.
Match MD24, MD25.
Removal of controller enable
during "Processing in prog-
ress".
Axis stopped (at same time, con-
troller enable is held until axis
comes to rest).
"Controller ready message" can-
celed whilst "processing in
progress".
Axis is stopped with actual
value transfer after axis comes
to rest (internally like "fol-
low-up mode").
FM 453 Servo Drive / Step Drive Positioning Module
C79000-G7076-C453-01
Message/
Display
CBS
CBS
CBS
CBS
CBS
Advertisement
Table of Contents
