Dodge RAM TRUCK 1500 1995 Service Manual page 469

— — VEHICLE SPEED CONTROL SYSTEM 8H -15
VACUUM RESERVOIR REMOVE/INSTALL
(1) Lift wiper arm to permit the latch (Fig. 20) to
be pulled out to the holding position. Remove arms
from pivots using a rocking motion.
CAUTION: The use of a screwdriver or other prying
tool to remove a wiper arm may distort it. This dis­
tortion could allow the arm to come off the pivot
shaft, regardless of how carefully it is installed.
Fig. 20 Removing Wiper Arms
(2) Remove weatherstrip along front edge of cowl
screen (Fig. 21).
Fig. 21 Cowl Screen Weatherstrip
(3) Release plastic anchor screws (Fig. 22).
(4) Move cowl screen aside far enough to access
reservoir in right cowl plenum area.
(5) Remove 2 push nuts and slide vacuum reser­
voir off studs (Fig. 23).
(6) Disconnect all hoses.
Fig. 22 Plastic Anchor Screws
Fig. 23 Vacuum Reservoir
(7) Reverse removal procedures to install. Refer to
Group 8K - Wiper and Washer Systems for correct in­
dexing of wiper arms.