Dodge RAM TRUCK 1500 1995 Service Manual page 473

8J - 4 TURN SIGNAL AND HAZARD WARNING SYSTEMS BR
SERVICE PROCEDURES
WARNING: ON V E H I C L E S E Q U I P P E D WITH AN AIR-
B A G , R E F E R TO G R O U P 8M - RESTRAINT S Y S ­
T E M S B E F O R E ATTEMPTING S T E E R I N G W H E E L
COMPONENT DIAGNOSIS OR S E R V I C E . FAILURE
TO TAKE P R O P E R PRECAUTIONS COULD R E S U L T
IN ACCIDENTAL A I R B A G DEPLOYMENT AND P O S ­
S I B L E P E R S O N A L INJURY.
MULTI-FUNCTION SWITCH REMOVE/INSTALL
(1) Disconnect battery negative cable.
(2) If equipped, remove tilt column lever.
(3) Remove both upper and lower shrouds from col­
umn (Fig. 4).
(4) Remove multi-function switch tamper proof
mounting screws (tamper proof torx bit Snap On
TTXR20B2 or equivalent required).
(5) Gently pull switch away from column. Loosen
connector screw. The screw will remain in the con­
nector.
(6) Remove wiring connector from multi-function
switch (Fig. 5).
(7) Reverse removal procedures to install. Tighten
fasteners as follows:
• multi-function switch connector screw - 1.9 N-m
(17 in. lbs.)
© multi-function switch retaining screws - 1.9 N-m
(17 in. lbs.).
UPPER
SHROUD
LOWER
SHROUD J9419-17
Fig. 4 Steering Column Shrouds Remove/Install
J918J-1 CONNECTOR
Fig. 5 Multi-Function Switch Connector