Figure 104: Installing An Ac Power Supply - Juniper M320 Hardware Manual

Figure 104: Installing an AC Power Supply

Related
Documentation
Copyright © 2015, Juniper Networks, Inc.
Firmly push the power supply into the chassis until it comes to a stop. The power
4.
supply faceplate should be flush with any adjacent power supply faceplates.
Tighten the captive screws on each side of the power supply faceplate to secure the
5.
power supply in the chassis.
Insert the appliance coupler end of a power cord into the appliance inlet on the power
6.
supply faceplate.
Remove the cable restraint from the right edge of the power supply faceplate by
7.
removing its retainer screw.
Wrap the cable restraint around the power cord, then slide it along the power cord to
8.
a position that enables you to reinstall it in the power supply faceplate.
Reinstall the cable restraint by tightening its retainer screw partway into the power
9.
supply faceplate.
Carefully pull the AC power cord through the cable restraint until you have the desired
10.
amount of slack in the power cord.
Tighten the cable restraint retainer screw to hold the power cord in place.
11.
Insert the power cord plug into an AC power source receptacle. Verify that the power
12.
cord does not block access to router components or drape where people could trip
on it.
Switch the powers seitch on the power supply faceplate to the on position (
13.
that the status LED on the power supply faceplate blinks, then lights
OUTPUT OK
steadily approximately 1 minute after you switch the power switch on.
M320 AC Power Supplies Description on page 73
M320 AC Power Electrical Specifications on page 101
Connecting Power to an AC-Powered M320 Router on page 173
M320 AC Power Electrical Safety Guidelines on page 345
Chapter 28: Replacing Power System Components
| ). Verify
249