M320 Ac Power Cord Specifications - Juniper M320 Hardware Manual

M320 Multiservice Edge Router Hardware Guide
Related
Documentation

M320 AC Power Cord Specifications

102
NOTE: If you plan to operate a maximally configured AC-powered router, we
recommend that you provision at least 14 A @ 240 VAC (or 17 A @ 200 VAC)
for the system, or at least 10 A for each power supply.
Each AC power supply has a single AC appliance inlet that requires a dedicated AC power
feed and a dedicated 15 A (250 VAC) circuit breaker. Use a facility circuit breaker rated
for 15 A (250 VAC) minimum for each AC power supply. Doing so enables you to operate
the router in any configuration without upgrading the power infrastructure.
M320 AC Power Supplies Description on page 73
Replacing an M320 AC Power Supply Cord on page 254
Most sites distribute power through a main conduit that leads to frame-mounted power
distribution panels, one of which can be located at the top of the rack that houses the
router. An AC power cord connects each power supply to the power distribution panel.
Detachable AC power cords, each 2.5 m (approximately 8 ft) long, are supplied with the
router. The appliance coupler at the female end of the cord inserts into the appliance
inlet on the faceplate of the AC power supply. The coupler is type C19 and C19W (right
angle) as described by International Electrotechnical Commission (IEC) standard 60320.
The plug at the male end of the power cord fits into the power source receptacle that is
standard for your geographical location.
WARNING: The AC power cord for the router is intended for use with the
router only and not for any other use.
WARNING: Translation from Japanese: The attached power cable is only for
this product. Do not use the cable for another product.
Copyright © 2015, Juniper Networks, Inc.