Copyright © 2015, Juniper Networks, Inc.
Place one hand underneath the power supply to support it, and slide it completely
6.
out of the chassis.
CAUTION:
Each power supply weighs approximately 10 lb (4.5 kg). Be
prepared to support the full weight of the power supply as you remove it
from the router.
Repeat the procedure for the remaining power supplies.
7.
Attach the installation handle by tightening the captive screws of the handle into the
8.
holes previously occupied by the captive screws of the power supplies in slots
and
(see
Figure 38 on page
PEM3
Figure 37: Removing an M320 Power Supply Before Installing the
Installation Handle
Figure 38: Attaching the M320 Installation Handle
Chapter 17: Installing the M320 With a Mechanical Lift
137).
PEM1
137