Installing An M320 Front Air Filter; Figure 75: Removing The Front Air Filter; Figure 76: Replacing The Front Filter Element - Juniper M320 Hardware Manual

M320 Multiservice Edge Router Hardware Guide

Installing an M320 Front Air Filter

204

Figure 75: Removing the Front Air Filter

Figure 76: Replacing the Front Filter Element

To install the front air filter (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Insert the filter element into the air filter frame.
2.
Grasp the air filter by the handles on its faceplate, and slide it straight into the chassis.
3.
Tighten the captive screws on the corners of the faceplate.
4.
Unlock the cable management system, and lower it to the fully lowered position.
5.
Rearrange the PIC cables in the cable management system.
6.
Figure 77 on page 205):
Copyright © 2015, Juniper Networks, Inc.