Management Cable And Transceiver Specifications And Pinouts; M320 Routing Engine Interface Cable And Wire Specifications; Table 68: Cable And Wire Specifications For Routing Engine Management And - Juniper M320 Hardware Manual

CHAPTER 13
Management Cable and Transceiver
Specifications and Pinouts

M320 Routing Engine Interface Cable and Wire Specifications

Related
Documentation
Copyright © 2015, Juniper Networks, Inc.
M320 Routing Engine Interface Cable and Wire Specifications on page 115
M320 RJ-45 Connector Pinouts for the Routing Engine ETHERNET Port on page 116
M320 DB-9 Connector Pinouts for the Routing Engine AUX and CONSOLE
Ports on page 116
Table 68 on page 115 lists the specifications for the cables that connect to management
ports and the wires that connect to the alarm relay contacts.
Table 68: Cable and Wire Specifications for Routing Engine Management
and Alarm Interfaces
Port Cable Specification
Routing Engine RS-232 (EIA-232) serial
console or cable
auxiliary
interface
Routing Engine Category 5 cable or
Ethernet equivalent suitable for
interface 100Base-T operation
Alarm relay Wire with gauge
contacts between 28-AWG and
14-AWG (0.08 and 2.08
2
mm )
M320 Routing Engine Description on page 24
M320 Connector Interface Panel (CIP) Description on page 13
M320 Site Preparation Checklist Requirements on page 85
Cable/Wire Maximum
Supplied Length
One 6-ft (1.83-m) 6 ft
length with (1.83 m)
DB-9/DB-9
connectors
One 15-ft (4.57-m) 328 ft
length with (100 m)
RJ-45/RJ-45
connectors
NO None
Router
Receptacle
DB-9 male
RJ-45
autosensing
—
115