Supplies; Figure 39: Installing The M320 Router In The Rack - Juniper M320 Hardware Manual

Removing the M320 Installation Handle and Reinstalling the Power Supplies
Copyright © 2015, Juniper Networks, Inc.

Figure 39: Installing the M320 Router in the Rack

NOTE: This illustration depicts the router being installed in an open-frame
rack.
After you have installed the router, remove the installation handle and reinstall the power
supplies in the chassis, starting from the bottom (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Loosen the captive screws on the installation handle completely, and remove the
2.
handle from the chassis.
Switch the circuit breaker on the power supply faceplate to the off position (
3.
Using both hands, slide the power supply into the chassis until you feel resistance.
4.
Firmly push the power supply into the chassis until it comes to a stop. The power
5.
supply faceplate should be flush with any adjacent power supply faceplates.
Chapter 17: Installing the M320 With a Mechanical Lift
Figure 40 on page 140):
).
O
139