Figure 36: Center-Mounting Bracket Removal - Juniper M320 Hardware Manual

Moving the Adjustable Center-Mounting Brackets for M320 Open-Frame Racks
Copyright © 2015, Juniper Networks, Inc.
Partially insert screws into the open holes in the flanges of the small shelf.
3.
Tighten all the screws completely.
4.
The router has two adjustable center-mounting brackets that are initially attached to
the mounting holes closest to the rear of the chassis. You can move the pair of adjustable
center-mounting brackets to one of 11 positions on the side of the chassis. The mounting
holes for connecting the mounting brackets to the chassis are spaced 0.984 in. (25 mm)
apart.
To move the adjustable center-mounting brackets to a different location on the side of
the chassis:
Loosen the three screws at the top and bottom of each bracket (see
1.
Figure 36 on page 133.
Align each mounting bracket with the mounting holes on the chassis that correspond
2.
to your rack mounting option.
Insert the three screws at the top and bottom of each mounting bracket, tightening
3.
each partway.
Tighten all the screws completely.
4.

Figure 36: Center-Mounting Bracket Removal

Chapter 16: Installing the Mounting Hardware
133