Figure 68: Installing A Cip - Juniper M320 Hardware Manual

Related
Documentation
Copyright © 2015, Juniper Networks, Inc.
Tighten the screws at the top and bottom of the CIP faceplate.
5.
Reattach any external devices connected to the CIP.
6.
CAUTION: Be sure to slide the CIP straight within the slot to avoid
damaging the connector pins on the front of the midplane.
To verify that the CIP is installed correctly, plug an Ethernet cable into the Ethernet
7.
port on the CIP. If the host module is operational, the
Ethernet activity. If you can run the CLI, the CIP is installed correctly.

Figure 68: Installing a CIP

Preventing Electrostatic Discharge Damage to an M320 Router on page 318
M320 Routing Engine Description on page 24
M320 Connector Interface Panel (CIP) Description on page 13
Connecting the M320 Router to a Management Console or Auxiliary Device on page 165
M320 Routing Engine Interface Cable and Wire Specifications on page 115
Chapter 24: Replacing Chassis Components
LED blinks to indicate
ACTIVE
191