M320 Multiservice Edge Router Hardware Guide
Related
Documentation
Installing the M320 Mounting Hardware for Open-Frame Racks
130
To remove the adjustable center-mounting brackets:
Loosen the three screws at the top and bottom of each bracket (see
1.
Figure 34 on page
130).
Remove the center-mounting bracket.
2.
Figure 34: Center-Mounting Bracket Removal
M320 Site Preparation Checklist Requirements on page 85
To prepare to center-mount the router in an open-frame rack, you install both the large
and small mounting shelves. The small mounting shelf and adjustable center-mounting
brackets are needed only if you are center-mounting the router. To prepare to front-mount
the router in an open-frame rack, install the large mounting shelf on the rack.
Two adjustable center-mounting brackets are attached to the center of the chassis (in
the mounting holes closest to the rear of the chassis). Optionally, you can move the
adjustable center-mounting brackets to any of 11 positions on the side of the chassis.
The spacer bars are not needed to center-mount the chassis; however, you can leave
them attached to the front-mounting flanges.
Copyright © 2015, Juniper Networks, Inc.