Removing An M320 Rear Air Filter; Figure 77: Installing The Front Air Filter - Juniper M320 Hardware Manual

Removing an M320 Rear Air Filter

Copyright © 2015, Juniper Networks, Inc.

Figure 77: Installing the Front Air Filter

The rear air filter is located at the left rear edge of the chassis. The rear air filter weighs
less than 1 lb (0.5 kg).
To remove the rear air filter:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Loosen the captive screws at the top, center, and bottom of the air filter, using a
2.
Phillips (+) screwdriver, number 2.
Grasp the air filter cover by the captive screws, and pull firmly to remove the cover
3.
and honeycomb assembly from the chassis (see
Press the filter element inward until it clears the hooks at the top and bottom of the
4.
air filter slot, then push it to the left to unseat it.
Move the tabs on the filter element to a horizontal position.
5.
Grasp the tabs on the filter element and carefully pull it straight out from the chassis
6.
(see Figure 79 on page
Chapter 25: Replacing Cooling System Components
Figure 78 on page
207).
206).
205