Powering On The M320 Router; Figure 66: Connecting Dc Power To The M320 Router - Juniper M320 Hardware Manual

M320 Multiservice Edge Router Hardware Guide
Related
Documentation

Powering On the M320 Router

176
Verify that the power cabling is correct, that the power cables do no touch or blocki
11.
access to Routerrouter components, or drape where people could trip on them.
Replace the clear plastic cover over the terminal studs on the faceplate.
12.

Figure 66: Connecting DC Power to the M320 Router

M320 DC Power Supplies Description on page 74
M320 DC Power Electrical Safety Guidelines on page 346
General Electrical Safety Warnings for Juniper Networks Devices on page 341
Preventing Electrostatic Discharge Damage to an M320 Router on page 318
To power on the router:
Verify that the power supplies are fully inserted in the chassis and that the captive
1.
screws on their faceplates are tightened.
For each power supply on an AC-powered router, verify that the source power cord is
2.
securely inserted into the appliance inlet. For each power supply on a DC-powered
router, verify that the source power cables are connected to the appropriate terminal:
Copyright © 2015, Juniper Networks, Inc.