Figure 45: Removing The Rear Fan Tray - Juniper M320 Hardware Manual

Multiservice edge router

Hide thumbs Also See for M320:

Table of Contents

To remove the rear fan tray (see

Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect

the strap to an approved site ESD grounding point. See the instructions for your site.

Loosen the captive screws on the top and bottom of the fan tray faceplate, using a

Phillips (+) screwdriver, number 2.

Grasp the handle and pull the fan tray halfway out of the chassis.

When the fans stop spinning, place one hand under the fan tray to support it, and pull

the fan tray completely out of the chassis.

Figure 45: Removing the Rear Fan Tray

Chapter 18: Installing the M320 Without a Mechanical Lift

Figure 45 on page

Table of Contents