Figure 105: Disconnecting Power Cables From The Dc Power Supply - Juniper M320 Hardware Manual

Copyright © 2015, Juniper Networks, Inc.

Figure 105: Disconnecting Power Cables from the DC Power Supply

Remove the cable lugs from the terminal studs.
6.
Loosen the captive screws on the cable restraints on the right edge of the power
7.
supply faceplate.
Carefully move the power cables out of the way.
8.
Loosen the captive screw on each side of the power supply faceplate completely.
9.
Twist the ejector handles on the upper corners of the faceplate counterclockwise to
10.
unseat the power supply.
Pull firmly to start removing the power supply. Slide it halfway out of the chassis (see
11.
Figure 106 on page 252).
WARNING: Do not touch the power connectors on the rear of the power
supply (see "Removing an M320 AC Power Supply" on page
contain dangerous voltages.
Place one hand underneath the power supply to support it, and slide it completely
12.
out of the chassis.
Chapter 28: Replacing Power System Components
247). They can
251