Installing An M320 Console Or Auxiliary Cable; Figure 68: Routing Engine Console Or Auxiliary Cable - Juniper M320 Hardware Manual

M320 Router Hardware Guide
146
Pull the cable connector straight out of the port.
3.
Disconnect the cable from the console or auxiliary device.
4.

Figure 68: Routing Engine Console or Auxiliary Cable

Installing an M320 Console or Auxiliary Cable

To install a console or auxiliary cable:
Turn off the power to the console or auxiliary device.
1.
Connect one end (shown in Figure 69 on page 147) of the replacement serial cable
2.
into the appropriate CONSOLE or AUX port. The external device ports on the CIP. The
ports labeled connect to the Routing Engine in the upper Routing Engine slot
HOST 0
Copyright © 2010, Juniper Networks, Inc.