Holding And Storing M320 Fpcs; Holding M320 Fpcs - Juniper M320 Hardware Manual

M320 Multiservice Edge Router Hardware Guide

Holding and Storing M320 FPCs

Holding M320 FPCs

272
Holding M320 FPCs on page 272
Storing M320 FPCs on page 275
CAUTION: Many components on the FPC are fragile. Failure to handle FPCs
as specified in this document can cause irreparable damage.
NOTE: An FPC configured with PICs installed can weigh as much as An empty
FPC1 or FPC2 weighs 15 lb (6.8 kg), and an empty FPC3 weighs 16 lb (7.3 kg).
A fully configured FPC can weigh up to 29 lb (13.2 kg). Be prepared to accept
the full weight of the FPC as you lift it.
CAUTION: To prevent damage when handling or carrying FPCs:
As you carry the FPC, do not bump it against anything. FPC components
are fragile.
Do not grasp the FPC anywhere except places that this document indicates.
In particular, never grasp the connector edge, especially at the power
connector in the corner where the connector and bottom edges meet (see
Figure 112 on page
Do not carry the FPC by the faceplate with only one hand (see
Figure 113 on page
Do not rest any edge of an FPC directly against a hard surface (see
Figure 114 on page
while changing its orientation between vertical and horizontal, use your
hand as a cushion between the edge and the surface.
273).
273).
274). If you must rest the FPC temporarily on an edge
Copyright © 2015, Juniper Networks, Inc.