Powering Off The M320 Router - Juniper M320 Hardware Manual

M320 Multiservice Edge Router Hardware Guide

Powering Off the M320 Router

Related
Documentation
178
To power off a T320 router:
On the external management device connected to the Routing Engine, issue the
1.
request system halt both-routing-engines
shuts down both Routing Engines cleanly, so their state information is preserved. (If
the router contains only one Routing Engine, issue the
user@host> request system halt both-routing-engines
For more information about these commands, see request system halt.
Wait until a message appears on the console confirming that the operating system
2.
has halted.
Halt the system ? [yes,no] (no) yes
*** FINAL System shutdown message from root@section2 ***
System going down IMMEDIATELY
Terminated
...
syncing disks... 11 8 done
The operating system has halted.
Please press any key to reboot.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
3.
the strap to one of the ESD points on the chassis.
Switch the circuit breakers on each power supply faceplate to the off position (
4.
Preventing Electrostatic Discharge Damage to an M320 Router on page 318
operational mode command. The command
request system halt
Copyright © 2015, Juniper Networks, Inc.
command.)
).
O