Positioning Of The Pc Drum Paper Separator Fingers [Separator Finger Solenoid - Minolta Di 620 Manual

4) Positioning of the PC Drum Paper Separator Fingers [Separator Finger
Solenoid]
Requirement
The gap between the three PC Drum Paper Separator Fingers and the PC Drum should be 0.3 to
1.0 mm when the Separator Finger Solenoid is OFF.
Adjustment Procedure
1. Open the Front Lower Door and loosen one screw to pull out the PC Unit.
2. Remove the Developing Unit and take out the PC Drum.
4. Move the PC Drum Separator Fingers Jig over the PC Drum Separator Fingers.
5. Adjust so that the tips of each separator finger matches the center between side A and side B of the
PC Drum Separator Fingers Jig when the Separator Finger Solenoid is OFF.
When the mounting angles of the three separator fingers are slightly uneven, it is acceptable if the
three separator fingers are positioned between side A and side B. To adjust, turn the adjustment
screw with a 3 mm Allen wrench.
NOTE
The PC Drum Paper Separator Fingers make a lateral motion when the Separator Finger Solenoid is
deenergized. Check must therefore be made when the fingers are located at the front end and the
rear end in their lateral movement.
• Turning in direction "a" lowers the tip of the separator finger.
• Turning in direction "b" lifts the tip of the separator finger.
3. Set the PC Drum Separator Fingers Jig against the
Cleaning Unit and fix it with the Front and Rear PC Drum
Lock Levers.
1075D148AA
Side A
Side B
1075D149AB
D-79
b
a
1075D150AA