Drum Dehumidify Function - Minolta EP2050 Operator's Manual

3. Drum Dehumidify Function

Job
Zoom
Memory Memory
Input
Meter
Count
OHP Cover
Inter- (Front)
leaving
Page
Cover
Insertion (Front
&
Toner Margin 1
Book 1
Book 2 Margin 2
Drum
Dehumidify
Display
Before a Drum
Dehumidify Operation
Drum
Dehumidify
Useful Tip
A copy cycle can be initiated even while the copier is in the Drum Dehumidify
Mode.
NOTE
The copier cannot be set into the Drum Dehumidify Mode while it is warming
up.
*1: Condensation: A phenomenon in which small drops of water are formed on
cold surfaces, such as the surface of the PC Drum.
*2: PC Drum: Functions in the copier as film in a camera.
During high humidity periods or when there
Auto Size
are sudden rapid changes in humidity
(especially when you are using a heater in
winter), condensation
Erase 1
surface of the PC Drum
Erase 2
Back)
blotchy copies. In such instances, use the
Erase 3
Drum Dehumidify Key to dry the surface of
the PC Drum.
Erase 4
OK
1136P354CA
1136P354CA
1136P358CA
1136P358CA
*1
could form on the
*2
After a Drum
Dehumidify Operation
1
Press the Drum Dehumidify Key.
This sets the copier into the
Drum Dehumidify Mode which
lasts for 3 minutes.
2 Make a copy to check that the
copy image is clear.
Run the Drum Dehumidify cycle
once again if the copy image is
not clear yet.
, resulting in
1136O176CA
131