3-5. ADJUSTMENT OF BELT TENSION
Checks after Adjustment
1) Turn the Timing Belt and check that all the Pulleys and grooves of the Belt fit securely.
2) Each Belt should flex a little when the Belt is lightly pressed with a finger.
Reference
Since a given tension is applied by a tension spring to the Tension Lever that maintains the tension
of each timing belt, adjustment is completed by re-tightening the mounting screw after it has been
loosened.
1) Adjustment of the Vertical Transport Section Timing Belt
2) Adjustment of the Paper Take-Up Unit Timing Belt
1. Remove the Rear Cover.
2. Remove one screw and the Large Capacity Cassette
Lattice Connector mounting bracket.
1161D005AA
3. Through the notch, loosen the screw by which the Tension
Lever is mounted as shown on the left and then re-tighten
it.
1075D131AA
1. Remove the Rear Cover.
2. Loosen the screw by which the Tension Lever is mounted
as shown on the left and then re-tighten it.
1075D132AA
D-72