14) Loop Adjustment
Requirement
Adjust so that a correct loop is formed at part A when paper is fed through.
Specification
Approx. 3.0 mm (visual)
NOTE
This adjustment is to be made when any of the following symptoms occurs: variations in the amount
of print leading edge void, paper skew, folded edge, and misfeed.
Adjustment Procedure
3. Press the Start key to let the copier take up and feed a sheet of paper and visually check that a
correct loop is formed at part A of the location shown below.
A
Advanced
The loop length is too long
causing the paper to have too
much slack.
Adjust Mode
Loop Adjustment
1. Open the Front Door and fit the Front Lower Door Interlock
Switch Actuating Jig.
1155D158AB
2. Slide out the Transport Tray, remove the lever, knob, and
cover, and slide the Transport Tray back into the copier.
1155D009AB
1155D161AA
Correct
A good length of loop is formed
as the paper moves into the
Synchronizing Rollers.
A
1155D159AA
D-98
Setting Range
-3 to +3
A
1155D160AA
Retarded
No loop is formed causing the
paper to be taut.