Table of Contents
Advertisement
1155SBS050408A
8) RD Mode
Touch Panel Display
RD Mode
ID Code
Maintenance
DT Setting
CT-ID
DT-ID
TEL No.
Initial Transmission
Data Save/Load
Data Save
Data Load
Call Completion
Counter Clear
Tech. Rep. Mode
For making the initial settings of the copier for the Data Terminal.
Enter a 7-digit ID code from the 10-Key Pad to enable making the following
settings. When the ID code is entered and transmitted after the initial set-
tings have been made, it executes the transmission of MAINT. START to
the Center.
Used to make the initial settings and various transmissions.
Enter the following data.
Enter the 4-digit ID number of the Center which has been programmed in
the Center personal computer.
Enter the 6-digit ID number of the Data Terminal.
Enter the 19-or-less-digit phone number of the modem connected to the
Center personal computer.
Note 1: When the office extension and outside line use different systems,
enter "P" for a "pulse" telephone line or "T" for a "tone" telephone
line before the outside line number.
Note 2: The time it takes the private branch exchange (PBX) system to
switch from the extension line to the outside line varies depending
on the type of PBX system used. Set this time as follows.
Fixed switching time: Enter the pause code "-" (a single "-" lasts 2
sec.)
Varying switching time: Enter the wait code "W".
Used to perform the initial transmission from the PPC to the Center to
check for correct communication when the Data Terminal has been set up.
Enables transmission of Data Save and Data Load.
Transmits the command that saves the PPC RAM data sent by Data Save
back to the PPC.
Used to perform the initial transmission from the PPC to the Center to
check for correct communication when the Data Terminal has been set up.
Used by the Tech. Rep. to notify the Center that his/her service job for the
copier has been completed.
Used to clear the count of the spare counter set by the Center.
<Procedure>
1. Touch [Counter Clear] to open the Counter Clear screen.
2. Touch the number assigned to the counter to be cleared.
S-45
RD Mode
Setting
Advertisement
Chapters
Table of Contents
