Table of Contents
Advertisement
2) Orig. Size Adjust
When is this adjustment required?
Be sure to perform the Orig. Size Adjust after the following items have been done.
1) Memory Clear
2) A faulty original size detection occurs.
3) Replacement of the CCD Unit and Scanner parts (including the Exposure Lamp)
Adjustment Procedure
2. Call the Tech. Rep. mode to the screen.
3. Touch [I.R. & EDH Check] and [Function (I.R.)], in that order.
4. Touch [Orig. Size Adjust].
5. Press the Start key to execute Orig. Size Adjust.
NOTE
The Start key remains lit up orange while this function is being run and lights up green as soon as
the sequence is completed.
6. If the adjustment was made okay, touch [Save] to save the adjustment value.
7. After the adjustment, touch [End] and then [Menu] to recall the Tech. Rep. mode to the screen.
1. Place a chart (a blank sheet of A4 lengthwise or Letter
paper) on the Original Glass and lower the Electronic
Document Hander.
1155D146AA
D-83
Advertisement
Chapters
Table of Contents
