Erasure Width - Minolta Di 620 Manual

Hide thumbs Also See for Di 620:

Table of Contents

16) Erasure Width

This adjustment must be made when a shadow is produced from the Original Scale.

Adjustment Procedure

5. Call the Tech. Rep. mode to the screen.

6. Touch [I.R. (EDH) Check] and [Tech. Rep. Choice], in that order.

7. Touch [Erasure Width].

Adjust so that dimensions A and B on the copy of the test

chart fall within the following specifications.

1. Set "Lead Edge Erase" of the printer to 0. (See p. D-95 for

the erase width setting procedure.)

2. Place the test chart on the Original Glass as shown on the

left and then lower the Electronic Document Hander.

3. Make one copy on A3 or 11" × 17" paper in the full size

4. Check if dimensions A and B on the copy meet the

specification. If dimensions A and B deviate from the

specification, adjust by following the procedure shown

Specification

Erasure Width

Table of Contents